SDR865 005 Baseband CPU IC – Qualcomm 5G RF Transceiver
₨ 250
Qualcomm SDR865 5G RF Transceiver IC
The SDR865 005 Baseband CPU IC is Qualcomm’s SDR865 single-chip 14nm RF transceiver, built for 5G sub-6 GHz and LTE on Snapdragon 865 and Snapdragon 765G platform phones. It links the modem to the RF front end, so a failed unit leaves the phone booting normally but showing no service or no 5G. Mechanicpk supplies this SDR865 transceiver IC for board-level network repair once you have isolated the transceiver as the faulty part. Match the chip marking against your board before rework, and use proper BGA reballing tools for a clean installation.
SDR865 Transceiver IC for Snapdragon 5G Network Repair
The SDR865 005 Baseband CPU IC is the Qualcomm SDR865 transceiver IC, the single-chip 14nm RF transceiver that sits between the modem and the antenna front end on Snapdragon 865 phones. Pakistani shops usually list it as a baseband or network CPU, but its real job is signal conversion: it turns modem data into RF signals for transmission and converts incoming RF back into data the modem can decode. When this chip fails, the phone loses its link to the cellular network while the applications processor keeps running, so the handset boots, displays and charges normally yet shows no service. You get a dedicated replacement part for that exact fault on Qualcomm 5G boards.
Where the SDR865 Sits in the Qualcomm 5G Chain
Qualcomm built the SDR865 for 5G sub-6 GHz and LTE operation, with support for FDD and TDD duplexing in both non-standalone and standalone 5G modes. The part first shipped inside the Snapdragon 765G platform in early 2020 and then appeared in the Snapdragon 865 platform alongside the Snapdragon X55 5G Modem-RF System. That history matters on your repair bench, because the same transceiver shows up on both flagship and upper mid-range Qualcomm boards from that generation. The chip handles a wider set of band combinations, higher uplink and downlink carrier aggregation, and 4G/5G dynamic spectrum sharing. A weak or damaged SDR865 rarely kills the whole radio at once; you often see partial symptoms first, such as LTE working while 5G drops, or one band group failing while others still connect.
Diagnosing a Faulty SDR865 Before Replacement
Confirm the fault before you lift the chip. Start with the software side: check the baseband version in settings, verify IMEI presence, and rule out a corrupted modem partition or damaged EFS/NV data, since a network issue after flashing looks identical to a hardware fault on the surface. If the baseband reads correctly and the IMEI shows normally, move to hardware. Measure the transceiver supply rails against a known-good board with your multimeter, and inspect the area under a microscope for corrosion, cracked solder balls, or underfill damage from an earlier rework attempt. Drop damage and liquid exposure commonly cause transceiver failure on flagship boards. A thermal camera or rosin test can also reveal a shorted line on the transceiver power rails. Replace the SDR865 only after you isolate it as the faulty component, because a no-service fault can also start at the modem, the power amplifier modules, or the antenna switches.
Replacement Workflow and Bench Requirements
The SDR865 uses a fine-pitch BGA package, so treat this job as board-level rework rather than a quick part swap. OEMs often apply underfill around RF chips on flagship boards, so plan an underfill removal step before the chip releases cleanly. Preheat the board on a PCB preheater, then use a hot air station with controlled airflow to lift the old chip without blowing away neighbouring passives. Clean the pads with solder wick and flux, then reball the new IC with the correct stencil from your reballing kit. Align the chip carefully under the microscope, reflow it, and let the board cool naturally before testing. After installation, check network registration on every supported technology and confirm signal strength across several bands. Compare the full marking on the old chip, including the 005 suffix, with the replacement before you start. Pair the job with a stable soldering station and a solid PCB holder, and SDR865 transceiver IC replacement becomes a repeatable service for any shop handling Snapdragon flagships.
| Weight | 0.1 kg |
|---|
Key Features
- ✓Genuine Qualcomm SDR865 RF transceiver for 5G sub-6 GHz and LTE
- ✓Single-chip 14nm design used on Snapdragon 865 and 765G platforms
- ✓Supports FDD and TDD duplexing in NSA and SA 5G modes
- ✓Handles wide band combinations and higher uplink/downlink carrier aggregation
- ✓Supports 4G/5G dynamic spectrum sharing
- ✓Fine-pitch BGA package for board-level rework
- ✓Restores network function where the transceiver causes no service
- ✓Suited to hot air rework and stencil reballing workflows
Specifications
| Brand | Qualcomm |
|---|---|
| Model | SDR865 (005 marking) |
| Category | Mobile Phone RF Transceiver IC |
| Compatibility | Snapdragon 865 platform (with Snapdragon X55 5G Modem-RF System) and Snapdragon 765G platform |
| Supported Devices | Smartphones built on the Snapdragon 865 and Snapdragon 765G platforms that use the SDR865 transceiver |
| Technology | Single-chip 14nm RF transceiver, 5G sub-6 GHz and LTE, FDD/TDD, NSA/SA, 4G/5G dynamic spectrum sharing |
Common Repair Uses
- ✓No service fault on a phone that boots and runs normally
- ✓5G not connecting while LTE still works
- ✓Single band or band-group failure after board damage
- ✓Network loss after drop damage to the RF section
- ✓Liquid-damaged RF section repair
- ✓Replacing a transceiver damaged during an earlier rework attempt
- ✓Weak or unstable signal traced to the transceiver on diagnosis
Compatible Devices
- ✓Chipset-platform scope; verify the SDR865 marking on the original chip before ordering
- ✓Snapdragon 865 platform smartphones
- ✓Snapdragon X55 5G Modem-RF System boards paired with Snapdragon 865
- ✓Snapdragon 765G platform smartphones
- ✓Qualcomm 5G sub-6 GHz boards that carry the SDR865 transceiver
- ✓Boards with an original chip marked SDR865 005
FAQ
What is the product name?
What is the brand of this product?
What is the model of this product?
What is this product used for?
Which devices are compatible with this product?
Who should use this product?
Is the SDR865 a baseband CPU or an RF transceiver?
Does replacing the SDR865 change or erase the IMEI?
Related products
358S IC T211 Samsung Tab Charging IC – Tab 3 USB Charger IC
In stock



