Mechanic UV559 Solder Paste Flux 10cc for BGA and SMD
₨ 350
Mechanic UV559 Solder Paste Flux for BGA and SMD Soldering
The Mechanic UV559 solder paste flux comes in a 10cc syringe with a plunger and dispensing tip, so you can place flux exactly where the joint needs it. It is built for BGA and SMD soldering, where a small amount in the wrong spot can ruin a reflow. On your repair bench, the syringe makes it easy to coat pads before placing a chip and to refresh flux during rework. Because you control the amount, you can work on tight pads without flooding nearby components. For board-level repair of smartphones and other compact electronics, this flux paste fits a steady, repeatable workflow.
In stock
UV559 Solder Paste Flux in Your BGA and SMD Workflow
The UV559 solder paste flux is a paste-form flux made for BGA and SMD soldering. In a repair workflow, flux goes on before reflow. You clean and prep the pads, apply flux, place the component, and then heat. The 10cc syringe format keeps the paste manageable on a busy bench, so you can use what you need without wasting material. This flux belongs to the pad preparation and reflow stage of board-level repair.
Where Flux Fits in the Reflow Stage
Flux prepares the metal surface before solder melts. It helps remove light oxidation from pads and supports solder flow across the joint. For a BGA component, that flow decides whether each ball bonds cleanly to its pad. You apply the paste to the board, not the chip, and then seat the component before reflowing. Check each pad under your microscope once the component is placed, so you catch bridges or uneven coverage early.
Syringe Application for Controlled Dosing
The syringe includes a plunger and dispensing tip, which lets you apply the paste in a thin, controlled line or a small dot. This matters on fine-pitch areas where excess flux can spread under nearby components. Press the plunger slowly and stop as soon as the pad is covered. Keep the tip clean between uses, and recap the syringe when you finish so the paste stays usable for the next job.
Pairing UV559 With Your Repair Bench Tools
Flux works best as part of a complete rework setup. Pair it with a hot air station for heat control, a reballing kit when you rebuild solder balls, and a microscope for inspecting joints. A PCB holder keeps the board steady during application and reflow. If your bench already runs a hot air station, this flux slots into the same workflow without changing your heat settings.
| Weight | 0.1 kg |
|---|
Key Features
- ✓10cc syringe with plunger and dispensing tip
- ✓Designed for BGA and SMD soldering
- ✓Paste form for targeted application on small pads
Specifications
| Brand | Mechanic |
|---|---|
| Model | UV559 |
| Category | Solder Paste Flux |
| Volume | 10cc |
Common Repair Uses
- ✓Applying flux to pads before BGA chip placement
- ✓Flux touch-up during BGA rework
- ✓Preparing pads before SMD component replacement
Compatible Devices
- ✓Universal, not device-specific. Verified scope covers BGA packages and SMD components.
- ✓BGA packages
- ✓SMD components
FAQ
What is the product name?
What is the brand of this product?
What is the model of this product?
What is this product used for?
Which devices are compatible with this product?
Who should use this product?
Does this flux need a special dispenser?
Is this flux suitable for BGA reballing prep?
Related products
JZQ-599B Soldering Iron Tip Cleaner with Tin Cleaning Ball
Out of stock
QIANLI 008 Cutting Knife Blade for BGA Underfill Removal
Out of stock



