SM5440 Charging IC for Samsung Galaxy A72 Board Repair
₨ 350
SM5440 Charging IC for Samsung Charging Section Repair
The SM5440 charging IC is a replacement chip for the charging section of Samsung Galaxy logic boards. It targets the faults that reach your bench most often: phones that refuse to charge, boards that hold zero current on a USB ammeter, and dead handsets with a short on the charging line. Technicians have recovered Galaxy A72 boards with dead and short faults through an SM5440 replacement. Mechanicpk supplies the exact marked part, so you complete a clean IC-level repair instead of pulling a chip from a donor board. Match the chip marking on your board before you order, then fit it with your hot air station and microscope for a reliable, repeatable charging repair.
SM5440 Charging IC: Replacement Part for Samsung Charging Circuit Repair
The SM5440 charging IC sits in the charging section of Samsung Galaxy logic boards. There it handles the power arriving from the USB-C port and feeds the battery path. When this chip fails, you usually see one of three symptoms on the bench: the phone refuses to charge, the charging current stays near zero on a USB ammeter, or the board shows a short on the VBUS line and the phone stays dead. Mechanicpk supplies the SM5440 as a new replacement component for technicians who diagnose down to IC level and want the exact marked part instead of a donor-board pull. Technicians have recovered Galaxy A72 boards with full dead and short faults through an SM5440 replacement. That makes it a common A72 charging IC job in the mid-range Samsung repair work that reaches Pakistani shops every week.
Diagnosing an SM5440 Fault Before You Replace It
Confirm the fault before you lift the chip. Start with a USB ammeter. A healthy charging section draws current within seconds of connection, while a failed SM5440 often holds the reading flat or drops it to zero. Next, measure the VBUS line to ground in diode mode with your multimeter. A dead short on that line, once you rule out the charging port and its protection components, points strongly at the charging IC. Feed the board from a DC power supply and use a thermal camera or freeze spray to find the hot component, because a shorted SM5440 usually warms up first. Check the charging port flex, the battery connector, and the battery itself too. A damaged port or a swollen battery produces the same “charging issue” complaint at the counter. Ruling these out saves you an unnecessary IC change karna job and spares the customer’s board extra heat cycles.
Replacing the SM5440 Charging IC on a Samsung Logic Board
Fix the board in a PCB holder and shield nearby plastic connectors, frames, and heat-sensitive chips with heat-resistant tape. Apply quality flux around the IC and lift it with your hot air station once the solder reflows fully, so the pads survive the removal. Clean the pads with solder wick and a fine soldering iron tip, then inspect them under a microscope for torn pads or solder bridges. Tin the pads evenly, align the new SM5440 with its pin-1 marking, and reflow it with steady, even airflow. Let the board cool naturally before you reconnect the battery. Finally, recheck VBUS for shorts, connect a charger, and watch the USB ammeter climb to a normal charging current. That reading confirms the repair before the phone goes back to the customer.
Matching the Right Samsung Charging IC to Your Board
Samsung uses several charging and power-management chips across its Galaxy range. The part number printed on the original chip decides the replacement, not the model name alone. Before you order any Samsung charging IC, open your schematic or board-layout viewer, find the charging section, and confirm the SM5440 marking on the board in front of you. For shops that handle frequent Samsung mid-range charging repairs, stocking this part in advance lets you finish the job the same day instead of waiting on a donor board. Pair it with a reliable hot air station, a microscope, a PCB holder, and a USB ammeter, and the SM5440 charging IC becomes a quick, repeatable fix that turns a dead phone back into a charging, working handset. When you want faster short hunting on every charging repair, a DC power supply with a precise current display is the natural next upgrade for your bench.
| Weight | 0.1 kg |
|---|
Key Features
- ✓Replacement charging IC marked SM5440 for Samsung Galaxy boards
- ✓Restores charging on boards with a confirmed charging IC fault
- ✓Clears dead-short faults on the charging line when the IC causes the short
- ✓Repair-verified on Samsung Galaxy A72 dead and short cases
- ✓New component, so you avoid donor-board pulls with unknown history
- ✓Fits standard hot air and microscope-based IC replacement workflows
- ✓Single-chip pack, suited to per-job stocking in repair shops
- ✓Supports same-day charging repairs for Samsung mid-range models
Specifications
| Model | SM5440 |
|---|---|
| Category | Mobile Phone Charging IC |
| Compatibility | Samsung Galaxy logic boards that carry the SM5440 marking |
| Supported Devices | Samsung Galaxy A72 (repair-verified) |
| Technology | Battery charging and power path management |
Common Repair Uses
- ✓Phone not charging with a healthy charging port and battery
- ✓Dead phone with a short on the VBUS/charging line
- ✓Charging IC heating up on a DC power supply
- ✓Zero or very low charging current on a USB ammeter
- ✓Charging section failure after a faulty or non-original charger
- ✓Charging faults after liquid damage near the charging section
- ✓Donor-free charging IC replacement on Samsung boards
- ✓Redoing a failed previous charging IC replacement
Compatible Devices
- ✓Scoped to boards carrying the original SM5440 marking. Confirm in your schematic before fitting.
- ✓Samsung Galaxy A72 logic boards
- ✓Samsung Galaxy boards that carry the original SM5440 marking in the charging section
- ✓Any board where the schematic lists SM5440 as the charging IC
FAQ
What is the product name?
What is the brand of this product?
What is the model of this product?
What is this product used for?
Which devices are compatible with this product?
Who should use this product?
How do I confirm the SM5440 is faulty on a Samsung phone that is not charging?
Can the SM5440 cause a dead phone with a short on the Samsung A72?
Related products
343S0694 Touch IC U2402 iPhone 6 and 6 Plus Touch Black IC
In stock
358S IC T211 Samsung Tab Charging IC – Tab 3 USB Charger IC
In stock



