7219M-31 IC Network PA Chip for Oppo A5s & Samsung A20s

₨ 400

7219M-31 RF Power Amplifier IC for Network Repair

The 7219M-31 IC is a replacement RF power amplifier chip for boards that carry this marking, including the Oppo A5s and Samsung Galaxy A20s. It amplifies the transmit signal from the RF transceiver before it reaches the antenna, so a damaged unit causes no service, weak signal, dropped calls, and failed network registration. Technicians fit it during board-level network repairs after ruling out the SIM tray, antenna connectors, and software faults. Installation calls for hot air rework, fresh flux, and microscope inspection. Match the full 7219M-31 marking on the original chip before replacement to keep your repair accurate.

10 People watching this product now!
Description

7219M-31 PA IC for Oppo A5s and Samsung A20s Network Repair

The 7219M-31 IC is a network power amplifier chip that drives the transmit side of the cellular RF section on boards such as the Oppo A5s and Samsung Galaxy A20s. When you fit a 7219M-31 PA IC, you replace the stage that lifts the low-level signal from the RF transceiver to the power the antenna needs to reach the tower. A failed or degraded PA often leaves the receive path partly alive, so the handset may show signal bars yet drop calls, fail to register, or report no service the moment it starts to transmit. Mechanicpk supplies this part for board-level technicians who have already traced a network issue to the PA area and need the exact marking for a clean swap.

RF Transmit Path and Fault Symptoms

The cellular signal path on these boards runs from the baseband through the RF transceiver, into the power amplifier, and then through the antenna switch and filters to the antenna. The 7219M-31 occupies the amplification step on the transmit side. That placement explains the typical symptom pattern: the phone reads the SIM, the IMEI stays intact, the baseband version shows correctly in software, yet registration and outgoing calls fail. A shorted PA also loads the supply rail it shares with other circuits, so a dead phone or abnormal current draw on your DC power supply can point back to this chip. Check the PA supply line for a short to ground before you condemn the PMIC or the processor.

Confirming the Fault and the Exact Variant

Rule out the simple causes first: the SIM tray, the antenna coaxial connectors, the antenna flex, and corrupted network data on the software side. Once those check out, inspect the PA area under a microscope for corrosion, lifted pads, or heat marks from an earlier rework attempt. Measure the supply and control lines around the chip with a multimeter and compare them with a known-good reference board. A short on the PA power line, a missing supply, or a chip that turns hot within seconds of power-on all justify the IC change. A healthy PA with network trouble shifts the focus to the transceiver, the antenna switch, or the filter components, so finish your diagnosis before you order parts. The 7219M family includes several suffix variants, such as -31, -41, and -71, and each suffix belongs to specific board designs. When you source an Oppo A5s network IC, read the full marking on the original chip and match the suffix exactly. A wrong variant can sit on the same footprint and still leave the phone without proper network performance.

Hot Air Replacement and Post-Repair Testing

The 7219M-31 power amplifier IC carries its solder pads underneath the package, so you need a hot air station, quality flux, and a PCB holder that keeps the board flat and stable. Shield nearby plastic connectors and shield-frame clips with heat-resistant tape, then preheat the board to reduce thermal stress on surrounding components. Lift the old chip once the solder flows, clean the pads with desoldering wick and fresh flux, and tin them with a thin, even layer. Align the new IC by its pin 1 marker and the silkscreen outline, then reflow until the chip self-centers on the molten solder. Let the board cool naturally before reassembly so the joints settle without stress. After the swap, check network registration on every SIM slot, place and receive voice calls, run a mobile data session, and watch the current draw during an active call. Stable registration, clear calls, and normal current confirm the repair. Keep a reballing kit and stencil on the same bench, since they cover most RF section work that follows a 7219M-31 PA IC replacement.

Additional information
Weight0.1 kg
Q & A
Please login to post questions

Key Features

  • Exact 7219M-31 marking for direct one-to-one replacement
  • Restores the cellular transmit amplification stage
  • Targets no service, weak signal, and call drop faults
  • Suits Oppo A5s and Samsung Galaxy A20s board repairs
  • Bottom-pad package for hot air rework
  • Supports board-level RF fault isolation workflows
  • Fits repair benches equipped with microscope and preheater
  • Suitable for service centers and repair shop stock

Specifications

Model7219M-31
CategoryMobile Phone ICs – RF Power Amplifier (PA) IC
CompatibilityBoards using the 7219M-31 marked PA chip
Supported DevicesOppo A5s, Samsung Galaxy A20s
TechnologyCellular RF transmit power amplification

Common Repair Uses

  • No service or “emergency calls only” faults traced to the PA stage
  • Weak signal and frequent call drops during active calls
  • Failed network registration with SIM and IMEI intact
  • Network loss after water damage or corrosion around the RF section
  • Short on the PA supply line causing abnormal current draw
  • Dead phone caused by a shorted PA loading a shared power rail
  • Replacing a PA damaged during a previous rework attempt
  • Restoring transmit performance after RF section board repair

Compatible Devices

  • Verified device-level compatibility plus marking-matched boards
  • Oppo A5s
  • Samsung Galaxy A20s
  • Other mobile boards carrying the original 7219M-31 marking (match the full marking before ordering)

FAQ

What is the product name?
The product name is 7219M-31 IC Network PA Chip.
What is the brand of this product?
Mechanicpk supplies this product as a replacement chip identified by its 7219M-31 marking.
What is the model of this product?
The model of this product is 7219M-31.
What is this product used for?
This product is used for replacing a faulty RF power amplifier to fix no service, weak signal, dropped calls, and network registration faults.
Which devices are compatible with this product?
This product is compatible with the Oppo A5s, the Samsung Galaxy A20s, and other boards that carry the original 7219M-31 marking.
Who should use this product?
This product is suitable for mobile repair technicians, repair shops, service centers, and professional users.
Can I use 7219M-41 or 7219M-71 in place of 7219M-31?
No. Each suffix belongs to specific board designs, so match the full 7219M-31 marking on the original chip to keep network performance correct.
How do I know the PA IC is faulty and not the antenna or transceiver?
Rule out the SIM tray, antenna connectors, and software first, then check the PA supply line for a short and inspect the chip for heat or corrosion. A healthy PA with network faults points to the transceiver, antenna switch, or filters.